The new Volvo MT2000 (Sweden) is a four-track, front-load, half-lane milling machine powered by a 610-horsepower Tier 3 Cummins engine. With the Volvo MT2000, Volvo brings innovation to milling equipment through features that increase productivity, serviceability, and overall safety.
The Volvo MT2000 offers three distinct engine and drum cutting speeds selectable from the operator's panel. The low-speed selection provides higher torque at a lower engine rpm to power through tough material or deep-cut applications. The high-speed selection is available for maximum travel speed on shallow cutting depths. The standard cutting speed is used to provide maximum horsepower and efficiency at normal cutting depths.
The Volvo MT2000 can run both 78.74-inch (2 000 mm) and 86.02-inch (2 185 mm) wide drums. In addition, the new Volvo MT2000 offers:
Four-track system with innovative features to improve milling performance
Independently controlled gathering and discharge conveyors with variable speed adjustment to meet cutting drum capacity
Dual operating stations with advanced technology in intuitive operator panels
Flexibility to control both sides of machine and front or rear from one grade and slope control panel
|